Electrochemical assisted abrasive flow finishing is a newly developed hybrid finishing process which is used to finish the internal parts of work piece having complicated geometry to large extent. In electrochemical assisted abrasive flow machining higher abrasion of the material was detected due to the combine effect of ECM and AFF processes. In Electrochemical aided abrasive flow machining a electrolyte is added to the prepared media. This media consist a kind of polymeric carrier and abrasive particles that are hydrocarbon gel, Al2O3, Silicon based polymer, and NaI (Sodium iodide) as electrolytic salt.
In this experimental research different process parameters such as voltage, abrasive concentration, Number of cycle, molal concentration and diameter of rod were considered at different levels for response characteristic of surface roughness (Ra) and material removal (MR) based on Taguchi method using standard L27 orthogonal array (OA) for the plan of experimentation. To determine the contribution of each parameter analysis of variance was used.
By Sandeep Singh | Sunil kumar" Experimental Research Work to Optimize Process Parameters into Electro Chemical Abrasive Flow Machining using Taguchi Methodology"
Published in International Journal of Trend in Scientific Research and Development (ijtsrd), ISSN: 2456-6470, Volume-1 | Issue-4 , June 2017,
Paper URL: http://www.ijtsrd.com/papers/ijtsrd80.pdf
Direct URL: http://www.ijtsrd.com/engineering/mechanical-engineering/80/experimental-research-work-to-optimize-process-parameters-into-electro-chemical-abrasive-flow-machining-using-taguchi-methodology/sandeep-singh
In this experimental research different process parameters such as voltage, abrasive concentration, Number of cycle, molal concentration and diameter of rod were considered at different levels for response characteristic of surface roughness (Ra) and material removal (MR) based on Taguchi method using standard L27 orthogonal array (OA) for the plan of experimentation. To determine the contribution of each parameter analysis of variance was used.
By Sandeep Singh | Sunil kumar" Experimental Research Work to Optimize Process Parameters into Electro Chemical Abrasive Flow Machining using Taguchi Methodology"
Published in International Journal of Trend in Scientific Research and Development (ijtsrd), ISSN: 2456-6470, Volume-1 | Issue-4 , June 2017,
Paper URL: http://www.ijtsrd.com/papers/ijtsrd80.pdf
Direct URL: http://www.ijtsrd.com/engineering/mechanical-engineering/80/experimental-research-work-to-optimize-process-parameters-into-electro-chemical-abrasive-flow-machining-using-taguchi-methodology/sandeep-singh
No comments:
Post a Comment